Colloidal Silica

Identification of agglomerates and aggregates in colloidal silicic acid

Silica sol, also known as colloidal silicic acid, is a stable suspension of spherical silicon dioxide (SiO2) nanoparticles in a liquid, that are hydroxylated on the surface. Colloidal silicic acid is found in almost all industrial sectors. The applications range from surface treatment in the paper industry, to use as a polishing agent in the electronics industry and use as an additive for varnishes, coatings and paints to improve weather and abrasion resistance. It is also a common additive in cosmetics and in the food industry. The mean particle size and distribution width define the field of application of the SiO2 particles. Typical sizes range from 1 nm to 100 nm.

Read more

Suspensions of fine amorphous silica particles in a liquid

Colloidal silicas are suspensions of fine amorphous, nonporous, and typically spherical silica particles in a liquid phase. It may be produced by Stöber process from Tetraethyl orthosilicate (TEOS).

Properties

[

edit

]

Usually they are suspended in an aqueous phase that is stabilized electrostatically. Colloidal silicas exhibit particle densities in the range of 2.1 to 2.3 g/cm3.

Most colloidal silicas are prepared as monodisperse suspensions with particle sizes ranging from approximately 30 to 100 nm in diameter. Polydisperse suspensions can also be synthesized and have roughly the same limits in particle size. Smaller particles are difficult to stabilize while particles much greater than 150 nanometers are subject to sedimentation.

Manufacture

[

edit

]

Colloidal silicas are most often prepared in a multi-step process where an alkali-silicate solution is partially neutralized, leading to the formation of silica nuclei. The subunits of colloidal silica particles are typically in the range of 1 to 5 nm. Whether or not these subunits are joined depends on the conditions of polymerization. Initial acidification of a water-glass (sodium silicate) solution yields Si(OH)4.

Hebei Silicon Research Electronic Materials Co., L supply professional and honest service.

If the pH is reduced below 7 or if salt is added, then the units tend to fuse together in chains. These products are often called silica gels. If the pH is kept slightly on the alkaline side of neutral, then the subunits stay separated, and they gradually grow. These products are often called precipitated silica or silica sols. Hydrogen ions from the surface of colloidal silica tend to dissociate in aqueous solution, yielding a high negative charge. Substitution of some of the Si atoms by Al is known increase the negative colloidal charge, especially when it is evaluated at pH below the neutral point. Because of the very small size, the surface area of colloidal silica is very high.

The colloidal suspension is stabilized by pH adjustment and then concentrated, usually by evaporation. The maximum concentration obtainable depends on the on particle size. For example, 50 nm particles can be concentrated to greater than 50 wt% solids while 10 nm particles can only be concentrated to approximately 30 wt% solids before the suspension becomes too unstable.

Applications

[

edit

]

See also

[

edit

]

References

[

edit

]

Are you interested in learning more about modified silica sol? Contact us today to secure an expert consultation!